ANNEX
.........................................................................................................................................................................................................
...............................................................................................................................................................................................................
Manual EMC 500 · EN01 · 2008-02
56
F
Assembly Instructions for Pipe Connections
Cut pipe perpendicularly and
remove fins. Insert pipe into
fitting until stop is reached.
Tighten nut with fingers only.
Prior to tightening the
SWAGELOK nut, mark it in
the 6 o'clock position.
Then tighten nut with
1¼
turns*
until marking reaches
the 9 o'clock position.
Removed fitting
Insert pipe with clamping
rings into fitting until stop is
reached
Tighten nut with fingers only,
then use wrench to tighten it
with approximately ¼ turn.
* For pipe connections sized 2, 3, 4 mm or 1/16", 1/8", 3/16", you must tighten the nut with a ¾ turn during
initial assembly.
INITIAL ASSEMBLY
珠海司福斯特科技有限公司
