5. PREPARATION BEFORE OPERATION
IMSRM52-E4
29
5.2 Transmission Speed Setting
Set the transmission speed between the control unit (H-LNK-A module) and
Control &
Communication Link
master station using the transmission speed setting switch at the rear of the
H-LNK-A module. To do this, use a small blade screwdriver.
Set the same transmission speed to the
Control & Communication Link
master station and
all the H-LNK-A modules on the same line. Otherwise, a normal data link cannot be made.
Setting procedure
1.
To separate the module mainframe from the mother block, press the bottom on the module, lifting
upward, to release connection.
2.
Set the transmission speed using the transmission speed setting switch at the rear of the
H-LNK-A module.
Setting range: 0 to 4
(Factory set value: 0)
0: 156 Kbps
1: 625 Kbps
2: 2.5 Mbps
3: 5 Mbps
4: 10 Mbps
5 to 9: Setting inhibited
Transmission speed
setting switch
H-LNK-A module
(Rear)
Mother block
Module mainframe
Upper
section
Mother block
Module mainframe
Lower
section
Press bottom of module and
lift upward to release
