10
Exiting Priming Modus
The system will automatically enter the normal heating and filtering at the end
of the priming mode, which lasts 4-5 minutes.
You can manually exit Priming Mode by pressing the “Exit” button on the
Priming Mode Screen. Note that if you do not manually exit the priming mode
as described above, the priming mode will be automatically terminated after
4-5 minutes. Be sure that the pump(s) have been primed by this time.
Once the system has exited Priming Mode, the top-side panel will display the
Main Screen, but the display will not show the temperature yet, as shown
below. This is because the system requires approximately 1 minute of water
flowing through the heater to determine the water temperature and display it.
3.5.1 Opening and closing the nozzles
The jets faceplate can be rotated clockwise to close them off. Turn the anit-
clockwise to open the water flow. The nozzles can be adjusted to a Center
position to reduce pressure from that jet. This may, however, automatically
adjust to open by the water pressure. If one or more jets is closed then the
pressure in the remaining open jets is automatically amplified.
Note: If a nozzle has too little power, this is usually because the jet is not open
properly.
3.5.2 Operation of Jet controls
The Jet control knob allows the water power of the massage pump to be
distributed between two opposing seats. When centrally adjusted, the power
of the massage pump is evenly distributed to both seats.
3.5.3 Intake
In the massage jets will automatically draw air into the jet stream when the
pumps are operated. This Air intake is below the spa shell and incorporated
in the cladding. A schematic of this air flow is not provided.
3.5
Operation of the massage
jets
Jetcontrol
Commissioning and Operation
