20
3.6.10 Auxiliary control panel (s)
3.6.11 Locking the operating keys
Commissioning and Operation
conditions. In colder climates, an optional freeze sensor may be added to protect
against freeze conditions that may not be sensed by the standard sensors.
Auxiliary freeze sensor protection acts similarly except with the temperature
thresholds determined by the switch. See your dealer for details.
Clean-up Cycle (optional)
When a pump or blower is turned on by a button press, a clean-up cycle begins
30 minutes after the pump or blower is turned off or times out. The pump
and the ozone generator will run for 30 minutes or more, depending on the
system. On some systems, you can change this setting. (See the Preferences
section on page 18).
Description of filter cycles
1. The heating pump is always running during the filter cycle. *
2. In idle mode the spas is heated only during the filter cycle.
3. cleaning at the beginning of each filter cycle.
* If your SPA is for example in the 24-hour circulation mode and the water
temperature is 3° F / 1.3° C below the set temperature, then the heating will
not turn off during the filter cycle.
Specific Buttons for Specific Devices.:
If the spa has an Auxiliary Panel(s) installed, pressing buttons on that panel
will activate the device indicated forthat button.
These dedicated buttons will operate just like the Spa Screen buttons (see page
5) and the equipment will behave in the same manner with each button press.
Restricting Operation: The control can be restricted to prevent unwanted
use or temperature adjustments. Locking the Panel prevents the controller
from being used, but all automatic functions are still active.
Locking the Settings allows Jets and other features to be used, but the Set
Temperature and other programmed settings cannot be adjusted. Settings
Lock allows access to a reduced selection of menu items. These include Filter
Cycles, Invert, Information and Fault Log. They can be seen, but not changed
or edited.
1. Please touch and hold the settings/screen for 2 seconds.
2. To finish please hold the top bar of the screen for 2 seconds until the
operating screen changes.
