8
3.1
Positioning the spa
3.2
Mounting the cover
Commissioning and Operation
The hot tub should be positioned on a flat firm surface. Support should be
given to the whole of the underside of the spa. For best results ensure that the
surface is flat and level across the diagonals of the base.
To mount the cover ( daybed or all weather) follow the steps below:
- Remove the 1.5 m long surround elements on the front and back of the
whirlpools from bottom to top.
- Remove insulation panels, front and rear and carefully store beside the
whirlpool.
- Unlock the four support rails with the clips at the end of the rails and
completely pull them out from the support frame.
- Remove the corner pieces of the surround elements on the front of the pool.
- Unpack cover carefully. Please make sure that the packaging film is not cut
with a sharp knife or blade. This could cause damage to the cover.
- One half of the cover is carried by two people and the edge beading threaded
into the piping profile underneath the top edge boards Fold cover on the hot tub.
Caution: Never let the hardtop hang down from the channel rail on the spa.
- Mount the second half exactly the same way and place it on the hot tub.
- Re- hang the corner surround elements.
- Replace the support rails and secure the clips back on to the ends.
- Pull out the support rails and check that they are locked in place.
- Now half of the cover can be placed on the support rail in the open position.
- The insulation and other surround panel elements can put back into place.
3. Commissioning and Operation
