Dok‑Guardian™ HD Safety Barrier
Installation/Service/Owner's Manual
Rite‑Hite
®
10 Publication:
AMEN00033 2019-03-29
INSTALLATION
Curtain
WARNING / AVERTISSEMENT
Spring under tension.
DO NOT unwind the roller spring!
Ressort sous tension.
NE PAS dérouler le rouleaux à ressort!
Adjustment
1 Adjust curtains, after wardens are secured in place
2 Pull the curtain across the door opening and secure
the latch bracket on the receiver warden
3 Pull the curtain completely out until the round retainer
bar engages the inner storage support Measure the
distance between the square latch bar and the latch
bracket
4 If the distance is less than 3-1/4in [825mm],
the installation is complete
5 If the distance is greater than 3-1/4in [825mm],
the latch bracket must be moved
a Walk the curtain back into its stored position
b Loosen the 3 bolts securing the latch bracket to
receiver warden
c Move the latch bracket away from the storage
warden the desired number of holes
d Tighten the 3 bolts securing the latch bracket to
receiver warden
e Refasten the latch bracket to receiver warden
Tensioning
A
B
If the top of the curtain “sags” or seems to be loose:
1 Angle the curtain attachment on the roller so the top
of the curtain is pulled slightly tighter With the curtain
pulled out and engaged, unroll the rest of the curtain
until the touch and hold fastener is accessible
2 Lock the roller with a screwdriver, by inserting the
screwdriver through the hole in the top of the storage
support (A) and 1 of the slots (B) in the roller tube
concurrently
3 Remove the curtain from the roller and angle the
curtain so the top of the curtain is slightly tighter Hold
the roller while removing the screwdriver Let the
curtain roll up slowly
4 Disengage the curtain from the latch bracket and roll
the unit up 2 or 3 times Engage the unit to see if the
curtain is tighter
5 Repeat to add more angle, if necessary
Figure 7
