Rite‑Hite
®
Installation/Service/Owner's Manual
Dok‑Guardian™ HD Safety Barrier
Publication:
AMEN00033 2019-03-29
9
INSTALLATION
Interlock/Interdeterrent
(OPTIONAL)
WARNING / AVERTISSEMENT
Interlock assembly is not intended for exterior use
or environments where it may get wet.
L'assemblage de verrouillage n'est pas
destiné à être utilisé à l'extérieur ou dans des
environnements où il peut être mouillé.
A
G
F
E
H
B
C
D
A Curtain Lead Bar
B Reinforcement Plate
C Switch
D Latch Bracket
E Interlock Assembly
F Magnet
G Control Box
H Use Open Hole to Locate
Interface Wiring
Left mount unit with Left to Right pull shown
Interlock / Interdeterrent Switch
1 Determine the correct location of latch bracket (D)
on warden to have the curtain provide the proper
stopping distance from impact
2 Ensure concentricity of magnet, large circular hole in
latch bracket (D) and available hole in reinforcement
plate (B)
3 Remove curtain lead bar (A)
4 Using reinforcement plate (B) as a template, drill a
1/2in [13mm] hole through the warden (not shown) to
pass the threaded body of the switch (C) to the back
side of the warden
5 Install switch (C) in hole leaving the sensing
face minimally recessed from the front surface of
latch bracket (D)
6 Wire switch (C) to options module on trailer restraint
Interlock (Actuator) Assembly
1 Drill 1/4in [64mm] hole through the warden at the
approximate location of available hole on front face of
interlock assembly (E)
NOTE:
The hole is provided only for the reversibility
of assembly and to approximate the location of this
hole for passing the power wires from the interface
board to the back side of the warden
2 Mount the interlock assembly (E) to the latch bracket
(D) using 2 screws provided
3 Feed wires through hole (H) and wire interlock
assembly (E) to options module on trailer restraint
4 Mount the power supplied control box (G) in a
convenient location on the back of warden or on the
wall
5 Repeat steps as necessary for common warden units
Figure 6
