dr
drY
Pr
---F or ---C
---
SbY
PHL
PHH
SAL
SAH
drn
rtC
PSt
CrC
Insufficient water detected flowing
through the heater.
Insufficient water detected flowing
through the heater (message
displayed on the third occurrence
of dry message). Spa will have
shut down.
When your spa is first connected
to power it will go into priming
mode.
Water temperature unknown.
Temperature does not appear
when spa is in Economy or Sleep
mode for an extended period.
Stand mode has been activated by
pressing a button combination on
the user panel.
pH level in water is low.
pH level in water is high.
Sanitiser level is low.
Sanitiser level is too high.
The pump is on during Standby
mode to assist in draining the spa.
Hardware failure.
Hardware failure.
Firmware install problem.
Check water level in spa. Add
water if necessary. If the water is
at the correct level make sure the
pumps have been primed. Press
any button to reset.
Check water level in spa. Add
water if necessary. If the water is
at the correct level make sure the
pumps have been primed. Press
any button to reset.
The priming mode will last up to
4 minutes and the spa will begin
to heat and maintain the water
temperature in the Standard mode.
After the pump has been running
for 1 minute the temperature will
be displayed.
If you wish to see the current spa
water temperature either switch to
Standard mode or turn on ‘VSP’
for a minimum of 1 minute.
Press any button except ‘VSP’ to
leave standby mode and return to
normal operation.
Add pH increaser according to
manufacturer’s instructions.
Add pH reducer according to
manufacturer’s instructions.
Add satiniser according to
manufacturer’s instructions.
Remove spa cover and allow
sanitiser to dissipate.
Press ‘VSP’ to turn off the pump
when the water has drained (or
power-off the spa).
Contact your dealer.
Contact your dealer if message
appears on more than one
power-up.
Contact your dealer if message
appears on more than one
power-up.
dIaGnostIC messaGes
Control Panel Message
Definition
Action required
TrOuBlesHOOTInG GuIDe
11
