varIaBle speed drIve
Press the variable speed drive button once
to turn it on or off. When turned on you can adjust
the current via the auxiliary control panel.
fIltratIon CyCles
The pump and the ozone generator will run during
filtration. At the start of each filter cycle the Variable
Speed Drive will run briefly on its lowest speed.
There are 2 filter cycles per day: 8.00am - 10.00am
and 8.00pm - 10.00pm.
The start/end times of each cycle are programmable.
To change the filter cycle settings press time then
the Mode button 3 times (within 3 seconds).
The PROGRAM, FILTER 1 and START TIME icons
will appear on the screen.
Press tempº + or tempº − to choose the Filter 1
start time hour. Set the hour by pressing mode.
Press tempº + or tempº − to choose the Filter 1
start time minutes. Each press changes the start time
by 5 minutes. Set the minutes by pressing mode.
Press mode to see the PROGRAM, FILTER 1 and
END TIME icons. Change the settings as for the
start time procedure.
Press mode to display the PROGRAM, FILTER 2
and START TIME icons and change as above.
Press mode to see the PROGRAM, FILTER 2 and
END TIME icons and change as above.
Finally, press mode and the new filter cycle times
will be entered into the system and the screen will
revert back to display the current water temperature.
Pressing time at any time during this programming
sequence will save the values entered up to that
point and exit programming.
The f1 icon will light when filter 1 is running. The f2
icon will light when filter 2 is running.
If you would like to select continuous filtration, set
the filter 1 start and end times to be the same.
In this case, the filter 2 start time only operates when
the second purge happens. Filter 2 end time will be
unavailable.
8
COnTrOl Panel OPeraTIOns
lIGHt
Press the light button to turn on the LED
lighting. Press the button once again to turn off the
lighting. Press the button a third time and you can
change the mode for the underwater LED lighting
and Multi Point perimeter LED light system. If left on,
the lighting will automatically turn off after a time-out
period.
freeze proteCtIon
If the temperature sensors within the heater detect
a very low temperature then the pumps and Variable
Speed Drive automatically activate to provide freeze
protection. The pumps and Variable Speed Drive will
run continuously or periodically depending on the
conditions.
loCKInG tHe Control panel
To lock the control panel press time then vsp then
tempº + each within 3 seconds. The pl indicator
will light up on the control panel. All buttons will be
frozen except the Time button. To unlock the panel
press time then vsp then tempº −.
loCKInG tHe temperature settInG
To lock the temperature setting press tempº +
then time then vsp then tempº + each within 3
seconds. To unlock press tempº+ then time then
vsp then tempº−.
Clean-up CyCle
At the beginning of the filtration cycle the Variable
Speed Drive will automatically operate for 1 minute to
clean the spa water.
CIrCulatIon pump
The circulation pump operates during filtration and
when the heater is in operation.
ozone Generator
The ozone generator will operate during filtration
cycles.
