Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 9 / 16

Acro Wot - Instructions
STEP 36
Apply epoxy to the slot in the rudder where the tailwheel wire will fit. Now slide
the rudder into position ensuring that the tailwheel wire and both hinges enter
their pre-cut slots/hole in the fin/rudder. Ensure a gap-free hinge line and a
1mm gap between the rudder counterbalance and tip of the fin.
STEP 37
Now add a couple of drops of thin cyano to both sides of each hinge. Make sure
that the glue does not run through the hinge line onto the other side of the fin.
STEP 38
Locate the factory assembled elevator pushrod and slide it into position from
the radio bay and out through the exit slot. It may help to use a scrap length of
snake inner to help guide the pushrod through the exit.
STEP 41
Cut the supplied single piece of closed loop wire into two equal lengths, then
fit a clevis and locking nut onto the closed loop adaptor. Now loop one piece
of the closed loop wire through the adaptor, and slip the brass tube supplied
over the join. Securely crimp with pliers. Repeat for the second length of wire.
For additional security we recommend a drop of cyano is used on each crimp.
STEP 40
Install your servos in the pre-fittted servo
tray as shown. Note the orientation of the
servo outputs. Use the mounting screws,
rubber grommets and ferrules supplied with
your radio.
STEP 39
Now screw a nylon clevis onto the elevator end of the pushrod as shown.
Mark and pilot drill two mounting holes in
the underside of the elevator then screw the
horn to the elevator. The screws thread into
the moulded horn plate on the top surface
of the wing.
Throttle
Rudder
Nose
Elevator
Radio Installation
9