Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 5 / 16

Acro Wot - Instructions
STEP 13
Adjust the pushrods to ensure that the ailerons are centred with the aileron
servos at their neutral position. Test to ensure that both ailerons move freely
across their entire throw.
STEP 12
Slide the aileron servo horn over the wire and re-fit to the servo. Snap a moulded
keeper onto the pushrod to retain it as shown.
Trim off the excess pushrod wire using side cutters. Repeat the procedure for
the second aileron in exactly the same way.
Installing the Undercarriage
STEP 14
Locate the aluminium main undercarriage, wheels and wheel mounting
hardware (axles, washers, nyloc nuts and collets). Pass the axle through the
undercarriage leg, slide over a washer, followed by the nyloc nut. Tighten the
nyloc nut, then repeat for the second axle.
STEP 15
Slide the wheel onto the axle and retain using a collet. File or grind a flat on the
axle where the point of the grub screw contacts to reduce the risk of it slipping.
Ensure the wheel spins freely and tighten the grubscrew securely. Repeat for
the other wheel.
STEP 16
Locate the undercarriage mounting bolts and washers. Screw the undercarriage
in place noting that the undercarriage legs rake forward. Use a drop of
threadlock on each for security.
5
STEP 17
Install the tailwheel on its axle and retain with a collet. Ensure the wheel spins
freely and that the grub screw is tightened securely.