Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 8 / 16

Acro Wot - Instructions
STEP 31
Repeat for the second elevator. Apply a small strip of tape to hold each elevator
half centred while the epoxy on the joiner cures.
STEP 32
Using white wood glue, epoxy or cyano, glue the fin in position ensuring that
the base is coated with adhesive. Ensure the fin is firmly pushed down in its
slot so that its base is in contact with the tailplane. Make sure the fin is at right
angles to the tailplane and allow the glue to dry.
STEP 33
Insert two hinges into the rudder, ensuring they are located mid-way in their
slots. Using thin cyano, pour a couple of drops onto each hinge - from above
and below - ensuring the glue soaks into the hinge and the surrounding wood.
STEP 34
Locate the pre-drilled hole in the rudder for the closed loop horn and pierce the
film on both sides using the tip of a needle file or sharp knife.
STEP 35
Assemble the closed loop horn from
the hardware supplied as shown.
Control
Horn
Threaded
Rod
Nut
Washer
8
STEP 30
Now slide the first elevator into position ensuring that the joiner enters hole in
the elevator and both hinges enter their pre-cut slots in the tailplane. Ensuring a
gap-free hinge line and a 1mm gap between the elevator and tip, add a couple
of drops of thin cyano to the top and bottom of each hinge. Make sure that the
glue does not run through the hinge line onto the bottom of the tail.