Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 12 / 16

Acro Wot - Instructions
STEP 54
Adjust the length of the linkage so that mid-throttle stick position corresponds
to the carburettor being open 50%. Tighten the screw in the connector and
adjust the high and low throttle positions.
STEP 55
Connect the fuel line to the engine, pressure to the exhaust (if using exhaust
pressure) and block the vent line.
STEP 56
Trim the fibreglass cowl to clear the engine and silencer. The cowl should just
overlap the front of the fuselage. Carefully measure the positions of the cowl
mounting blocks and transfer these measurements onto the cowl. Pilot drill the
cowl and retain with three self tapping screws, one top centre and one each
side. Fit your propeller and spinner. The model is complete and ready for final
installation - see Step 56.
STEP 57
Place your engine on the mount. Adjust its position until the distance from
the front of the the prop driver to the rear of the mount is 120mm. Mark the
positions of the engine mounting bolts.
STEP 58
Holding the engine steady, mark the position of the mounting holes on the
mount. Remove the engine and drill four clearance holes through the engine
mounting beams to suit the bolts supplied.
STEP 59
Prepare the fuel tank as shown in Step 42. The tank is installed in its bay via
the radio bay. Fit and identify your fuel tubes, then feed the tank into position,
drawing the fuel tubes out through the hole in the centre of the firewall.
Two Stroke Engine Installation
12