Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 13 / 16

Acro Wot - Instructions
STEP 60
Screw the engine to the mount using the four bolts, washers and nuts supplied.
Locate the throttle pushrod outer sleeve. Install the tube through the bulkhead
and secure with a drop of cyano. Form a 'Z' bend in the throttle pushrod. Fit to
the carburettor throttle lever and slide the pushrod into its outer. To do this, you
will need to temporarily remove the throttle lever from the carburettor.
STEP 61
Prepare your throttle servo horn by assembling a pushrod connector as shown
in Step 45. Slip the connector onto the pushrod and refit the servo control horn.
Adjust the length of the linkage so that mid-throttle stick position corresponds
to the carburettor being open 50%. Tighten the screw in the connector and
adjust the high and low throttle positions.
STEP 62
Connect the fuel line to the engine, pressure to the exhaust (if using exhaust
pressure) and block the vent line.
STEP 63
Trim the fibreglass cowl to clear the engine and silencer. The cowl should just
overlap the front of the fuselage. Carefully measure the positions of the cowl
mounting blocks and transfer these measurements onto the cowl. Pilot drill
the cowl and retain with three self tapping screws, one top centre and one
each side. Fit your propeller and spinner. The model is complete and ready for
balancing and setting up the control throws.
STEP 64
Cut a suitable aperture and fit your radio's switch to the left hand side of the
fuselage.
STEP 65
Connect and install your receiver in the radio bay with plenty of shock absorbing
foam. Temporarily install your radio's battery in the radio bay. Its final position
is determined after balancing the model.
Final Installation
13