Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 11 / 16

Acro Wot - Instructions
STEP 48
Holding the engine steady, mark the position of the mounting holes on the
mount as shown.
STEP 49
Remove the engine and drill four clearance holes through the engine mounting
beams to suit the bolts supplied.
STEP 50
Prepare the fuel tank for fitting by assembling the tank stopper with the feed,
vent and fuel pipes. Ensure the clunk tube length is cut to allow the clunk to
move around the tank without catching on the tank's base. Fit the assembled
tank bung and tighten the retaining screw. Take care not to over-tighten this
screw. Test that the tank is leak-proof.
STEP 51
The tank is installed in its bay via the radio bay. Fit and identify your fuel tubes,
then feed the tank into position, drawing the fuel tubes out through the hole in
the centre of the firewall.
STEP 52
Screw the engine to the mount using the four bolts, washers and nuts supplied.
Locate the throttle pushrod outer sleeve. Install the tube through the bulkhead
and secure with a drop of cyano. Form a 'Z' bend in the throttle pushrod. Fit to
the carburettor throttle lever and slide the pushrod into its outer. To do this, you
will need to temporarily remove the throttle lever from the carburettor.
STEP 53
Prepare your throttle servo horn by assembling a pushrod connector as shown.
Slip the connector onto the pushrod and refit the servo control horn.
11