Ripmax Acro Wot mk2, Инструкция по эксплуатации

Страница: 6 / 16

Acro Wot - Instructions
=
=
STEP 18
Screw the tailwheel assembly in position with the tailwheel wire in line with the
rear of the fuselage.
STEP 22
Remove the tailplane and cut away the covering from just inside the marked
lines to give a film-free surface for the glue to bond. IMPORTANT: Ensure that
only the film is cut - not the tailplane - as this will seriously weaken the structure.
STEP 23
Slide the fin into its pre-cut slot in the top of the fuselage. Ensure that it is
pushed down far enough to touch the top of the tailplane. Mark the fin on both
sides where it enters the fuselage using a soft, water-soluble pen.
STEP 21
Slide the tailplane into its pre-cut slot
in the rear of the fuselage. Ensure that
it is square to the fuselage and centred
in its slot using a long ruler or string as
shown in the diagram on the right. Mark
the tailplane on the top and bottom
where it enters the fuselage using a soft,
water-soluble pen.
Fitting the Tail and Fin
6
STEP 20
Carefully remove the film from the slot in the top of the fuselage where the fin
will mount.
STEP 19
Using a sharp knife, carefully remove the film from the slot in both sides of the
fuselage where the tailplane will mount. Trim away the covering to expose the
slots for the elevator pushrod and rudder closed loop exits.