Rinnai 23
RF1200TW OIM
BURNER MEDIA INSTALLATION
WARNING
ONLY use the burner media supplied by the manufacturer in this appliance.
DO NOT BURN WOOD OR ANY OTHER MATERIAL IN THIS APPLIANCE.
Logs, Coals and Granules
This burn media option consists of a set of
ceramic Coals, Logs (of various size and
shape) and Granules.
Refer to the table right for details on the
size and quantity for each of the supplied
burn media components.
Item
Size
Quantity
Coals
50mm x 50mm x 50mm
60
Y Shaped Logs
Ø35mm x 200mm
2
Straight Logs
Ø35mm x 200mm
2
Straight Logs
Ø35mm x 150mm
4
Twigs
Ø25mm x 150mm
12
Granules
Ø10mm ~ Ø20mm (Chunks)
280g
1. Place approximately 46 coals onto
the burner top taking care to not block
too many burner ports. There is no
set way to place the coals but the
following diagram can be used as a
guide. Take care not to cover the
aeration slots on the front of the
burner or block the pilot and tracking
holes on the burner top. Logs, Coals
and Granules.
2. Carefully
place
the granules onto the
burner in a single layer that covers
some of the holes in places where
they may be seen when finished and
also around the front and back of the
burner as a decoration.
IMPORTANT
Avoid pouring the media over the burner, as this can block the burner ports with the fine dust that
tends to settle in the bottom of the bags during shipping.
4. Place all the remaining coals and logs
on top of the coals that were placed
on the burner in step 1, ensuring that
there are plenty of gaps between
logs and coals.
5. Once all the logs and coals are in
place, light the fire and assess the
look of the flames.
IMPORTANT
If there are any areas that have very long streaky flames then, using a pair of tongs, move the top
logs or coals to another position until the flames are more even across the whole burner.
Pebbles / Crystals (Crushed Glass), Where Applicable
1. Place
DO NOT POUR
all of the supplied Pebbles or Glass evenly across the entire area of the burner. The
finished depth will be about 2 ~ 3 pebbles or about 20 mm of glass. Take care to keep the area directly around
the pilot burner clear of burner media.
2.
DO NOT
PILE
glass or pebbles over the top of the pilot assembly as this could affect it performance. It may
be possible to build the media up around the pilot to hide it slightly but always check that the pilot is operating
at its optimum when finished. (Refer to “Pilot Burner Performance” on page 22)
IMPORTANT
Avoid pouring the media over the burner, as this can block the burner ports with the fine dust that
tends to settle in the bottom of the bags during shipping.
