Rinnai IB35ETRLC, Руководство владельца по эксплуатации и установке

Страница: 17 / 32

17
The logset is packed inside the unit and
the packaging must be removed prior to
installing the logset in its correct position.
• Open both side panels.
• Remove fasteners on both sides of the
top glass retainer.
• Lift retainer away from unit.
• Loosen screws on bottom glass retainer.
• Carefully lift glass out of bottom channel.
• Carefully remove log packaging.
The logset has two holes underneath for
location onto the pins inside the unit.
Place the logset into the unit ensuring that
the locating pins enter the two locating
holes on the bottom face of the logset.
Gently place loose ember bed material
in front of the front log only. Do not
pour as dust particles from the plastic
bag may block the burner ports.
Level it with a pencil or screwdriver and
remove excess material. Note: The ember
bed material must be placed after the logs
are fitted. If the logs are to be removed for
any reason, the ember bed material must
be removed first and replaced after the
logs are refitted. Any material that prevents
the logs sitting flat on the burner top can
upset the burning pattern and performance
of the heater.
• Replace glass and top glass retainer,
tighten bottom glass retainer screws.
Note: Fit glass so that the joint in the glass
seal is at the bottom.
• Take care not to damage seals.
• Reinstall side panels.
LOG INSTALLATION
WARNING: Failure to position the parts
in accordance with these diagrams or
failure to use only parts specifically
approved with this appliance may result in
property damage or personal injury.
Note: When first lighting the heater, the
logs need to be burnt in, which may take
approximately 2 hours. The flame color
may change after the initial burning in
period.