RIKA PELLET CONTROL, Руководство по эксплуатации

Страница: 6 / 24

Page 6 of 24
We recommend that a cable length of 30 ft is not exceeded and a cable cross-
section of 0,5 to 0,75 mm
2
is used.
In accordance with the operating instructions of your stove, remove the right-
hand rear side panel or the rear panel.
After routing the cable, guide the cable through the plastic grommet (figure 1).
Push it through the bracket and connect to connector 3 (figure 2).
Fig. 1: Routing of cable through, Fig. 2: Plug position on the main
rear panel board
Connect the control cable in the correct wire sequence to the 4-pin plug
supplied (as shown in figure 4). Plug the plug into the socket of the pellet
control. Now snap the front section of the pellet control into the rear housing
panel.
Fig. 3: Multiple pin strip cable of the pellet control