RIKA PELLET CONTROL, Руководство по эксплуатации

Страница: 19 / 24

Page 19 of 24
The number below shows the remaining time until exit in seconds (here 300).
On completion of EXIT 2 the display goes dark. Re-start commences only if the
“ON/OFF key is pressed.
Note:
The full shut-down process lasts for about 8 minutes and cannot be interrupted
by the user. Operation of “ON/OFF” causes the shut-down to be re-initiated.
•
Switching over from automatic operation (TM)
Heating time controlled automatic stop
If in automatic operation “AUTOM TEMP OFF” is set to “OFF”, then the stove
will be shut down upon completion of the functions described above.
On completion of the shut-down phase the following appears on the display:
The clock symbol (red marking) indicates the automatic
mode. The symbol indicates the standby state of the controls.
“OFF” indicates that the pellet stove is switched off and is
waiting for frost protection operation or for the next
programmed heating period.
The stove is re-started to operate automatically by the start of a programmed
heating period or can be started any time manually by the user by switching to
the ON mode (e.g. when heat is needed outside the programmed heating
periods).
Manual automatic stop
If during automatic operation “ON/OFF” is pushed, the stove switches
automatically to the shut-down phase. The same display appears as
mentioned above.
On completion of the EXIT 2 phase the display darkens and the device can
only be re-set to automatic mode by pushing the “ON/OFF” button.
OFF