RF800 [Revision 1.0.0] 01.08.2018
Shafts Geometry Measurement Machine. RF800 Series
11
Parameter
Default
value
Note
Calibration diameter D
20 mm
The diameter of the caliber installed in the Morse taper (see p.
5.2.
).
Tolerance for
calibration
0.002 mm This tolerance is used when testing the calibration accuracy (see p.
7.3.
).
Motor step
453
Linear displacement of the micrometer, which corresponds to one step
of the motor.
This parameter can be changed only by the manufacturer.
To save changes, tap
Save
.
7.2.4. Operator
Tap
Operator
. The following window appears:
In this window, you can select, edit, delete, or add the new operator.
7.2.5. Part
In the program, the measured parts are shown as templates described by the
following parameters: the position of the controlled zone on the shaft, its size and diameter,
and the tolerances for sorting. The number of zones is up to 8. To set the template
parameters, tap
Part
. The following window appears:
