18
Shafts Geometry Measurement Machine. RF800 Series
RF800 [Revision 1.0.0] 01.08.2018
8.1.1. Visual inspection
Before operating, it is needed to ensure of the serviceability of the machine:
·
check the cables and ground wires,
·
check the condition of output windows of the micrometer, and, if necessary, wipe
them with a soft lint-free cloth.
8.1.2. Installation
Install the machine on the equipment. Connect the power cable (220V).
8.1.3. Switching on the machine
Feed power to the machine by switching on the circuit breaker, see Figure 3.
8.1.4. Setting parameters and forming the database of templates
Set parameters in accordance with p.
7.2.
Form the database of templates in
accordance with p.
7.2.5.
8.1.5. Calibration
Calibrate the machine in accordance with p.
7.3.
The calibration procedure must be
performed:
·
daily before the work shifts,
·
in case of changing the shaft type,
·
if the position of the machine was changed.
8.1.6. Metrological verification
Metrological verification of the machine must be performed:
·
before commissioning,
·
after repair,
·
periodically during operation.
8.2. Working with the machine
The measurement of geometrical parameters is fully automated and the work with
the machine is reduced to the mechanical adjustment, and then to the work with the
software. Follow the steps below:
·
Configure the machine to operate with the shaft of the appropriate diameter, see
par.
8.2.1.
·
Configure the machine to operate with the shaft of the required length, see par.
8.2.2.
·
Start the software, see par.
7.
·
Install the controlled shaft into the machine.
ATTENTION:
It is necessary to clean the shaft from cutting fluid and oil before
installing into the machine!
·
Tap the
Measurement
button.
