RF800 [Revision 1.0.0] 01.08.2018
Shafts Geometry Measurement Machine. RF800 Series
15
7.2.5.3. Saving the part template
To save the part template, tap
Save
. The program returns to the list of controlled
parts and displays the parameters of the saved template.
7.2.6. Workplace
The machine can be installed on workplaces of various types (production line,
quality control department). On production lines, only one selected zone is measured at
each workplace. During the quality control, the whole shaft is measured without sorting into
groups) To set the workplace type and its description, tap
Workplace
.
The list of workplace numbers is shown in the left side of the window.
The workplace number of the machine is marked with
.
Description of the workplace (in the right side of the window) is given for the
workplace number highlighted in blue in the list to the left.
If the
QC
toggle is enabled, this workplace relates to the quality control department,
and the measurements are performed in full (without sorting into groups).
To describe the workplace (not QC), disable the
QC
toggle and follow the steps
below:
