RF800 [Revision 1.0.0] 01.08.2018
Shafts Geometry Measurement Machine. RF800 Series
7
5.3. Operating principle
After the measurement algorithm has been programmed (position and number of
controlled zones along the shaft, tolerances, etc. - see the software description), the
operator installs a shaft into the machine. After a command from the operator (by the foot
switch, or by the softkey on the touch screen), the linear translation system moves the
micrometer along the shaft. The data from the micrometer (shaft diameters in two mutually
perpendicular cross sections) synchronized with the linear position of the micrometer
comes to the computer where the required parameters are calculated (shaft diameter and
shaft shape error).
6. Basic technical data
Parameter
Value
Shaft length, mm
160...750
Shaft diameter, mm
5...30
Accuracy, m
±1
Time of measuring the shaft of the
maximum length, s, no more than
20
Number of controlled shaft zones and their
position
Programmable value
Maximum shaft weight, kg
2
Measured parameters
Diameter, ovality, taper
Sorting "OK"-"NOK"
Yes
Ability to sort by groups
Yes
Power supply
Three-phase alternating current network with frequency of (50 ±
1) Hz, nominal voltage 220 / 380V with a permissible voltage
deviation of ±10%.
Power consumption, W
100
Environmental resistance
Operating ambient temperature: +1...+35°С
Relative humidity for 25°С: 65%
Operation mode
3 shifts, 6 days a week
Dimensions, mm
380х428х1079
Note:
Machine parameters can be changed for a specific task
