53
20095002
GB
Maintenance
7.3
Opening the burner
Loosen the 4 screws 1)(Fig. 41) and remove the hood 2).
Disconnect the plug 7) and unscrew the cable grommet 8).
Disconnect the socket from the maximum gas pressure
switch.
Remove the screws 3) and move the burner backwards by
about 100 mm on the slide bars 4).
Disconnect the electrode lead and then pull the burner fully
back.
At this point it is possible to extract the inner part 5) after
having removed the screw 6).
7.4
Closing the burner
Push the burner up to approximately 100 mm from the pipe
coupling.
Reconnect the cables and slide in the burner until it comes
to a stop.
Connect the plug of the servomotor 7) and tighten the grom-
met 8).
Connect the socket of the maximum gas pressure switch.
Replace the screws 3) and carefully pull the electrode cable
outwards until it is slightly taut.
Disassemble the two extensions from the guides 4).
DANGER
Disconnect the electrical supply from the burner
by means of the main system switch.
DANGER
Close the fuel interception tap.
Wait for the components in contact with heat
sources to cool down completely.
4
6
7
1
3
2
5
1
8
Fig. 41
D9071
After carrying out maintenance, cleaning or
checking operations, reassemble the hood and all
the safety and protection devices of the burner.
Содержание RS 160/EV BLU TC
