5841
5
F
3.
INSTALLATION
3.1
INSTALLATIONS ALIMENTATION HUILE COMBUSTIBLE
INSTALLATION AVEC BOUCLE
Pour huile lourde avec viscosité jusqu’à 50°E/50°C
.
NOTES IMPORTANTES
- Pour faciliter l’écoulement du fioul les tuyauteries doivent être dûment dimensionnées, calorifugées et réchauf-
fées (électriquement, à vapeur ou à l’aide d’eau chaude).
- La pompe de transfert devra avoir un débit d'au moins deux fois supérieur à celui de la pompe du brûleur.
S’il y a plus d’un brûleur alimenté par la même boucle, alors la pompe de transfert devra avoir un débit d’en-
viron 30% au-dessus du total des débits de chaque brûleur.
- Mise en marche: avec le brûleur exclu à l’aide des vannes (5) faire circuler le fioul dans le boucle d’alimenta-
tion. Lorsqu’on a obtenu une circulation à régime, ouvrir les vannes et alimenter régulièrement le brûleur.
INSTALLATION A GRAVITE
Seulement pour huile avec viscosité jusqu’à 7°E/50°C.
Attention:
avant la mise en marche du brûleur contrôler si le tuyau de retour n'est pas bouché.
Si c'est le cas, l'organe d’étanchéité de la pompe risque d'être endommagé.
1 - Citerne (réchauffée pour huile lourde)
6 - Brûleur
2 - Filtre (avec résistance pour huile > 7°E/50°C)
7 - Régulateur de pression
3 - Pompe de transfert
8 - Filtre (avec résistance pour huile > 7°E/50°C)
4 - Manomètre de contrôle
9 - Pompe du brûleur
5 - Vannes pour exclusion brûleur (accouplées)
D2734
H
mètres
L mètres
ø 1”
ø 1 1/4”
0
2
10
0,5
3
11
1
4
12
1,5
5
13
2
6
14
Amorçage de la pompe:
desserrer le bouchon du raccord vacuo-
mètre (6, fig. 1) et attendre la sortie du
combustible.
H: Dénivellation
L: Longueur du tuyau d’aspiration
D2735
H
m
a
x
.
3
0
m