5
2A GETTING STARTED
2.1A PARAMETERS ACCESS
Pressing the MENU key for at least 2 sec provides access
to the P1 menu, allowing the parameters to be programmed.
If the case the menu is empty, P8.04 is displayed, otherwise
the first item in the menu appears.
IMPORTANT
The parameters dedicated to the user are the following:
Menu Parameters
Scrolling message
only if parameter
P1.05 = 1
Value Password
level
P1
SETTINGS
P1.01
LANGUAGES
0 IT
1 RO
2 FR
3 EN
4 SR
5 HR
6 ES
7 EL
8 BG
9 PL
10 SL
USER
P1.02
TIME
USER
P1.03
TIME PROGRAM
Only if clock is
enabled - see 8.16
P1.05
SCROLLING
0 / 1
USER
P1 (SETTINGS menu)
P1.01
Select the parameter to set the desired language (see above
table).
P1.02
From this menu the time and the number of the day of the week can
be adjusted.
P1.03
Available only if embedded clock has been enabled.
P1.05
This parameter allows you to enable scrolling text after the
parameter code itself:
0= OFF
1= ON
2.2A PROGRAMMING THE BOILER
Ensure the gas and electrical supplies to the appliance are
switched on.
With power on the backlight comes on, then all the icons
and the segments come on for 1sec and in sequence the
firmware revision is displayed for 3sec:
Then the interface displays the status active at that moment.
If necessary, the interface automatically goes to the clock
menu. On the main screen the icons
,
, and and
ENTER come on while 00:00 is displayed with the first two
digits blinking with a frequency of 0.5 sec ON, 0.5 sec OFF.
To set the time and day proceed as follows:
set the hour with the
and
arrows, then confirm with
A
set the minutes with the
and
arrows, then confirm
with
A
set the day of the week with the
and
arrows. The
segment of the day selected blinks, press MENU at the
icon
Enter
per to confirm the time and day setting. The
clock blinks for 4sec and then returns to the main screen
to exit the time programming without saving the modified
values, just press .
NOTE: It is possible to change the TIME and DAY settings
also later by accessing the P1.02 parameter in the P1 menu,
or by pressing the
A+C
keys for at least 2sec.
RESET
+
MENU
+
C
A
If you need to set the
language
, select the menu P1 and
confirm your choice using
.
Use the arrows to display parameter P1.01, then enter the
submenu by pressing .
Use the
and
buttons to set the desired language
– see “
2.1a PARAMETERS ACCESS”
. To confirm your
choice, press
Enter
.
