Riello 20052615, Инструкции по установке, использованию и обслуживанию

Страница: 20 / 50

3087
2
GB
1. BURNER DESCRIPTION
Two stage gas burner.
1.1 BURNER EQUIPMENT
Flange with insulating gasket . . . . . No. 1 Screws and nuts for flange to be fixed to boiler . . . . No. 4
Screw and nut for flange . . . . . . . . . No. 1 7 pin plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Remote reset connection . . . . . . . . . No. 1 4 pin plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
1.2 ACCESSORIES
SOFTWARE DIAGNOSTIC KIT
A special kit is available that, by an optical link to a PC, shows the burner life together with operating hours, type
and number of failures, serial number, etc.
To visualise the diagnostics proceed as follows:
➤ Connect the kit supplied separately to the control box socket.
Reading of the information begins when the software programme included in the kit starts.
REMOTE RESET KIT
The burner has a remote reset kit (RS) consisting of a connection and a push-button operating at a dis-
tance of 20 metres max.
In order to install it remove the protective lock-out installed at the factory and insert the lock-out supplied
with the burner (see electrical diagram on page 7).
MULTIBLOC ROTATION KIT
There is a special kit available that can be used to install the burner turned 180°, as illustrated on page 5 in
position 5 in the section entitled "3.1 WORKING POSITION". This kit is designed to ensure the gas train
valve works properly. The kit must be installed in conformity with laws and local regulations.
1 – Air pressure switch
2 – 6 pole socket for gas train
3 – Control box with 7 pole socket
4 – Reset button with lock-out lamp
5 – Head holder assembly 6 – Flange with insulating gasket
7 – Servomotor
8 – Blast tube
9 – 4 pole socket for 2
nd
stage burner
10 – Motor
➤
The burner meets protection level of IP 40, EN 60529.
➤
CE marking according to Gas Appliance Directive 90/396/EEC; PIN 0085BN0325.
➤ According to Directives: Machine Directive 2006/42/EC, Low Voltage Directive 2006/95/EC and Electro-
magnetic Compatibility 2004/108/EC.
➤ The burner is approved for intermittent operation as per Directive EN 676.
➤
Gas train according to EN 676.
Fig. 1
D7111
1
4
2
5
10
3
6
7
9
8