16 — English
OPERATION
CAUTION:
On a level surface with the engine off, check the
lubricant level before each use of the generator.
STARTING THE ENGINE
See Figures 21 - 22.
NOTE:
If location of generator is not level, the unit may not
start or may shut down during operation.
Unplug all loads from the generator.
Turn the fuel valve to the ON position.
Place the idle control switch in the OFF position.
Move the choke lever right to the START position.
NOTE:
If engine is warm or the temperature is above
50˚F, move the choke lever left to the RUN position.
Place the engine switch in the ON position.
Slide the lock button down and push the engine switch
to the START position. Hold until the engine starts.
NOTE:
The battery may require charging before the gen-
erator can be started using only the engine switch. The
generator can be started by pulling the recoil starter grip.
Once the generator is started, the battery will charge as
the unit runs.
The generator can also be started by pulling the recoil
starter grip until the engine runs (a maximum of 6 times).
NOTE:
Do not allow the grip to snap back after starting;
return it gently to its original place.
Allow the engine to run for 30 seconds, then move the
choke lever left to the RUN position.
Place the idle control switch in the ON position.
STOPPING THE ENGINE
See Figures 21 - 22.
To stop the engine under normal operating conditions:
Remove any load from the generator.
Turn the fuel valve to the OFF position.
To stop the engine, place the engine switch in the OFF
position on the removable control panel or press and hold
the engine switch on the stationary control panel.
NOTE:
If it is necessary to shut the engine off immediately,
either off switch may be used if the removable control panel
is connected to the unit.
WARNING:
While operating and storing, keep at least 3 feet
of clearance on all sides of this product, including
overhead. Allow a minimum of 30 minutes of “cool
down” time before storage. Heat created by muffler
and exhaust gases could be hot enough to cause
serious burns and/or ignite combustible objects.
HIGH ALTITUDE OPERATION
Specific modifications are needed for high-altitude operation.
Please contact your authorized service center for important
information regarding these modifications. Operating this
engine without the proper altitude modification may increase
the engine’s emissions and decrease fuel economy and
performance.
