10 — English
PRODUCT SPECIFICATIONS
ENGINE
Engine Type .......................Yamaha MZ360, 4 Stroke, OHV
Bore x Stroke .............................................85 mm x 63 mm
Cooling System ...................................................Forced Air
Compression Ratio ...................................................... 8.1:1
Starting System ......................................................... Recoil
Ignition System ............................................................T.C.I.
Spark Plug .....................................................NGK BPR4ES
Engine Lubricant Volume...........................................1.1 qt.
Fuel Volume ................................................................ 8 gal.
FEATURES
GENERATOR
Rated Voltage .....................................................120V/240V
Rated Amps ..................................................... 56.7A/28.3A
Rated Output ..........................................................6,800 W
Maximum Output....................................................8,500 W
Rated Frequency ........................................................60 Hz
DIMENSIONS
Length ....................................................................... 36 in.
Width .......................................................................... 23 in.
Height ......................................................................... 26 in.
Weight .................................................................... 245 lbs.
KNOW YOUR GENERATOR
See Figure 3.
The safe use of this product requires an understanding of the
information on the product and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload. The circuit breaker may be reset
by pressing the circuit breaker reset button.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
ENGINE SWITCH
The engine switch is used either alone or in combination
with the recoil starter grip to start the generator. To turn the
engine off, place either engine switch in the “OFF” position.
FUEL TANK
The fuel tank has a capacity of 8 gallons.
FUEL VALVE
The flow of fuel through the generator is controlled by the
position of the fuel valve.
GenSmart™ MONITORING SYSTEM
The GenSmart monitoring system tracks usage and load
and alerts the operator when periodic engine maintenance
is needed.
NOTE:
GenSmart
™
load indicator monitors the load only
for the 120 Volt, 20 Amp GFCI outlets on the removable
control panel. It does not measure load on the 240 Volt,
30 Amp outlet.
GROUND TERMINAL
The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
IDLE CONTROL SWITCH
When turned on, the idle control switch allows the gen-
erator to sense when no load is present. In response, the
generator will begin idling at a lower RPM, which will help
conserve gasoline and lessen the noise being produced by
the generator.
OFF SWITCH
The generator has two off switches: one on the removable
control panel and one on the stationary control panel. To
turn the engine off, press and hold the OFF switch until the
engine stops.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAIN PLUG
When changing the engine lubricant, the oil drain plug is
removed to allow old engine lubricant to be drained.
