10
ASSEMBLY
RAISING AND LOWERING THE HANDLE
See Figure 4.
To raise the handle: pull the handle up until the handle
knob snaps through the locking hole to secure the handle
in place.
To lower the handle: pull the handle knob out then lower
the handle to the position shown in figure 4.
WARNING:
Make sure the nozzle and hose connections are
secure before starting the machine. A non-secured
accessory could become a projectile if not properly
installed which could result in serious injury.
ASSEMBLING THE TRIGGER HANDLE
See Figure 5.
Place
the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
Turn the connector clockwise until it stops. This
secures
the wand in place.
When not in use, remove the spray wand from the trigger
handle by turning the connector counterclockwise.
Store
the unassembled spray wand in the spray wand sto
rage
area.
ATTACHING THE AUXILIARY HANDLE
See Figure 5.
Place the threaded stud on the end of the auxiliary handle
into the hole in the trigger handle as shown below. Turn
clockwise to tighten.
NOTE:
You can install the handle on either the left or right
side of the spray wand, depending on operator prefer-
ence. The handle must always be used to prevent loss
of control and possible serious injury.
To switch sides, loosen the auxiliary handle and rotate to
the opposite side. Tighten securely before use.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See
Figure 6.
Pull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
Fig. 4
Fig. 5
AuXILIARY
HANDLE
SPRAY
wAND
TRIGGER
HANDLE
CONNECTOR
HANDLE
HANDLE
KNOB
LOwERING THE HANDLE
fRONT
SuPPORT
