17
English
Introduction
Changing the battery of the remote control
Press firmly and slide
1.
the battery cover off.
Put the cover
3.
back.
Install new battery into the
2.
compartment.
Remove the old battery
and install new one
(CR2025). Ensure that
the side with a “+” is
facing up.
M
n
O
2
-
L
iCE
LL
3
VO
LT
SJ
AP
AN
H
CR2025
3
VO
LT
S
CR2025
M
3
VO
LT
S
CR2025
To ensure safe operation, please observe the
following precautions :
■ Never throw batteries into a fire.
■ Do not ingest battery, Chemical Burn Hazard.
■ Keep new and used batteries away from children.
For more detailed information, please see p.9.
Remote Control Operating
When pointing the remote control directly toward the projector (Remote control signal receiver),
y
operating range for the remote control is within 4 m (13.12 ft). Also, operation range available for
four directions (up, down, left, right to the projector) is ± 35° and the operation distance may become
short.
If there are any obstacles between the remote control and the remote control signal receiver, the
y
remote control may not operate correctly.
You can operate the projector by reflecting the remote control signal on the screen. The operating
y
range may differ due to the loss of light caused by the properties of the screen.
When the remote control signal receiver is lit with a fluorescent light or other strong light source, the
y
projector may become inoperative. Set the projector as far from the luminous source as possible.
You can operate all of the functions of the projector via the remote control. Make sure not to lose the
y
remote control.
Before using the remote control for the first time, remove the transparent insulation sheet.
y
Transparent insula-
tion sheet
4m(13.12ft)
±35°(horizontal)
±35°(Vertical)
4m(13.12ft)
±35°(horizontal)
±35°(Vertical)
