Ricoh D067, Руководство по обслуживанию

Страница: 319 / 676

System Service Mode (F/SPF: D068/D069)
D067/D068/D069/D072 5-10 SM Appendix
2928 Toner End Clear
2928 1
Clears the following messages and counters without supplying the toner:
ƒ Toner near end message
ƒ Toner end message
ƒ Toner near end counter
ƒ Toner end counter
Do not use this SP in usual operations. When the toner in the development
unit is abnormally insufficient, the drum may attract the toner carrier to its
surface. The toner carrier damages the drum surface..
2929* Vref Limits Adjust the upper or lower Vref limit.
2929 1 Upper [0.50 to 3.50 / 3.20 / 0.01V/step] DFU
2929 2 Lower
[0.50 to 3.50 / 0.70 / 0.01V/step] DFU
2994* ID Detect Temp
[30 to 90 / 30 / 1
°
C/step]
2994 1
Adjusts the temperature threshold. The ID sensor signal is not referenced
when the fusing temperature is at the specified level or higher while the
copier is recovering or starting up.
2996* T Roller Cleaning [ 0 = No / 1 = Yes]
2996 1
Cleans or does not clean the transfer roller before each job. Select “1” if the
backside of the paper becomes unclean when output. Note that the copier
takes a longer time to output the first copy when you select “1”. If you select
“0”, the transfer roller is never cleaned.
2998* Main Mag- print [–0.5 to +0.5 / 0.0 / 0.1%/step]
2998 1
Adjusts the magnification ( "Adjusting Copy Image Area" in the section
"Replacement and Adjustment"). The specification is 100 ± 1.0%.