17
Revision 2
Setting the Limit Travel Stops:
Closed Position
•
Position gate 150-200mm back from
the gate end catch closed position.
This will help in making sure you do
not slam the gate into the end
stop/catch when setting the closed
position under power.
•
Fit limit travel stop onto the top of
gear rack at the point where it meets
the spring limit switch on the motor.
•
Tighten locking screws.
Open Position
•
Position gate 150-200mm back from
the gate stopper open position. This
will help in making sure you do not
slam the gate into the end stop/catch
when setting the open position under
power.
•
Fit limit travel stops onto the top of
gear rack at the point where it meets
the spring limit switch on the motor.
•
Tighten locking screws.
Test the spring limit travel stops by moving the gate manually until you hear a click,
making sure contact is made with the spring limit switch on the motor.
To Reset:
When setting new limit travel stop positions please ensure that you turn the
power off and then on again. Turning the power off will reset the limit travel stop
memory, allowing for new limit travel stop positions to be recognised by the motor.
Once satisfied the gate is opening and closing to the test limit switch position. Set the
limit travel stop positions in place (see Step 9 and Step 10 for instructions on powering
the motor and testing the limit switch positions).
Fig 21
Fig 22
