28
Revision 2
The below steps must be completed by a qualified electrician
Clearing Remote Controls:
To delete all paired remote controls, press and hold the button ‘S1’ for approx. 8
seconds. When
the ‘LEARN’ LED turns off, all previously paired remote controls will
be deleted.
Pairing Additional Remote Controls:
Remove motor outer cover and continue to remove the clear PCB cover, press the
button ‘S1’ on the control board, until the ‘LEARN’LED turns on, then release the
button. While the light is on, press the first button on the remote control twice, the
‘LEARN’ LED will flash repeatedly and then turn off when remote control is paired.
Technical Support
For support or assistance with installing your gate motor, contact our gate support
team:
Visit:
gatesupport.richmondau.com
AU:
03 9070 5713
NZ:
0800 61 71 81
International:
+613 9551 2233
Richmond Wheel & Castor Co declines all responsibility for any consequences resulting from
improper use of the product or use which is different from that expected and specified in the
present documentation.
Richmond Wheel & Castor Co declines all responsibility for any consequences resulting from
failure to observe Good Technical Practice when constructing closing structures (door, gates etc.),
as well as from any deformation which might occur during use.
Press and hold the learn
button (S1) until the Learn
LED flashes ON.
While the light is on,
press the first button on
the remote control twice.
The Learn LED will flash
repeatedly and then turn
OFF. when the remote is
paired.
