Rich electric Invertek SuperCombi SC-1500-12X, Руководство пользователя

Страница: 151 / 155

Rich Electric Co. “SuperCombi” User Manual V7.19 Copyright 2009
Page 151
Chapter 9 Trouble Shooting
z
Proceed as follows for a quick detection of common faults.
z
DC loads must be disconnected from the batteries and the AC loads must be disconnected from
the INVERTER before the INVERTER and/or battery charger (AC CHARGER) is tested.
z
Consult your Rich Electric dealer if the fault cannot be resolved.
Problem/Error message Possible Cause Solution
The “SuperCombi®” fails to
operate when power on.
The battery voltage is too
high or too low.
Ensure that the battery
voltage is within the correct
value range.
‘ ’: blink
The battery voltage is low.
Charge the battery or check
the battery connections.
The “SuperCombi®” cuts
out because the battery
voltage is too low.
Charge the battery or check
the battery connections.
‘ ’: blink
The load on the inverter of
“SuperCombi®” is higher
than the normal load.
Reduce the load.
“SuperCombi®” cuts out
due to excessive load.
Or “SuperCombi®” has
been Over Loaded and
caused Internal Damage.
Reduce the load.
If Overload warning does
not reset after restart the
“SuperCombi®” will need to
be sent to service for repair.
‘ ’: blink
The ambient temperature is
too high, or the load is
excessive.
Place the “SuperCombi®”
in a cool and well-ventilated
room, or reduce the load.
‘Udc-UV’
Battery under volt
Udc-UV
Battery under volt
‘OL’
Inverter OverLoad
OL
Inverter OverLoad
‘OH’
Heatsink Max Temp.