Rice Lake iRev 920i, Руководство по установке, Страница: 45 / 101

Using iRev 41
5.5.2 Uploading Configuration to iRev
The
Upload Configuration
function on the
iRev
C o m m u n i c a t i o n s m e n u a l l o w s t h e e x i s t i n g
conÞguration of a connected indicator to be saved to a
Þle on the PC. Once saved, the conÞguration Þle
provides a backup that can be quickly restored to the
indicator if needed. Or, the Þle can be edited within
iRev
, then downloaded back to the indicator.
5.6 Installing Software Upgrades
New releases of the
920i
system software can be
downloaded and installed using an internet connection
and the Rice Lake Web Update application.
Figure 5-5. Rice Lake Web Update Display
NOTE:
Before upgrading to a new version of 920i
system software, ensure that a copy of the current
indicator conÞguration has been saved using
iRev .
R e l o a d i n g t h e s y s t e m s o f t w a r e r e q u i r e s a
RESETCONFIGURATION function and will reset all
conÞguration and calibration values to their factory
defaults.
Click on the
Check for Updates
button in the Rice
Lake Web Update application to check if a new
version of the
920i software is available. To download
a new software version, select the new software
version and click on
Get Selection
. Once the new
software is downloaded to the PC, do the following:
1. Disconnect power to the 920i .
2. Connect the PC serial port to port 2 of the
920i . Connection must be made at 38400 bps.
3. Open the indicator enclosure and place a
jumper across the SW1 boot mode pins (see
Figure 2-4 on page 6).
4. Power up the 920i . The indicator will stall at
the diagnostic monitor.
5. Click on the
Update Indicator
button to
downloaded the new software. When the
download begins, the following messages are
shown:
Loading…
System Diagnostic Monitor v1.0
$KNIX
$SYSLOAD
6. When the download is complete, the indicator
display shows the following messages:
$DONE
$BOOT
Loading…
7. The indicator resets and goes to weigh mode.
8. Disconnect power to the indicator. Remove
the jumper from across the SW1 boot mode
pins and place it on a single pin.
9. Power up the indicator and reload
iRev
and
iRite Þles as necessary.