RIB JOLLY ONE AA00200, Руководство пользователя

Страница: 21 / 40

21
G
B
After have choosen JOLLY ONE according to the dimensions of the shutter, verify the
diameter of the spring housing and of the shaft, because they must have the same diameter
of the choosen motor.
If they’re different use the required adaptor:
ACJ9055 SPRING HOUSING ADAPTER Ø 200-220
ACJ9040 SHAFT ADAPTER Ø 42/60
ACJ9050 SHAFT ADAPTER Ø 48/60
A - Make the holes on the shaft as indicated on the rising above draw (see pict.1).
Note:
In case you are mounting a motor on an existing rolling shutter and it is difficult to drill
through the shaft, install the motor as per pic. 3 by drilling a 12 mm hole on centre of
62 mm.
Open the motor and mount it as indicated of continuation.
B - Open the pulley unscrewing the 2 screws (1).
C - Mount JOLLY ONE on the shaft and position the motor up and the limit switch down
(see pict. 3). Fix JOLLY ONE on the shaft using the fixing flange and its screws (2) and
(3) alternatively, (2) and (5) in case the installation is not done with a go-through hole.
D - Reassemble the pulley and re-screw its screws (1).
E - On the last section of the shutters make a hole Ø 12 mm / 0,4 in which allows to fix the
shutter to the pulley of the JOLLY ONE using the proper screws (4).
F - Insert the electrical cable and the releasing cable in the holes on the shaft (see pict. 3)
and execute the electrical connections.
HOW INSTALL JOLLY ONE WITH ELECTROBRAKE
IMPORTANT: Before install JOLLY ONE check that the shutter is correctly balanced by its screws mounted on the shaft. Verify it manually by opening and closing the shutter.
3
Respect the radius of the curve (at least 15 cm / 5,9 in)
Hole Ø 12 / 0,4 (entry of the release cable)
Hole diam. 12 / 0,4 (entry of electric cable)
Release Knob
=
Electric Cable
Electrobrake
62 / 2,4
Ø 12 / 0,4
=
5
NOT PASS-THROUGH HOLE
Measurements in mm/in
1
Hole Ø 12 / 0,4 (in vertical)(only for the cable of the brake)
Spring housing
Shaft
= =
Measurements in mm/in
35 / 1,38 250 / 9,85
450 / 17,7
Ø
200 / 7,9
Ø
60 / 2,3
Ø 12 / 0,4 (frontal) pass-through hole
PASS-THROUGH HOLE
Hole Ø 12 / 0,4 (frontal) (entry of electric cable)
IMPORTANT
2
1
1
3
2
1
4
2