42
3.2
FIXING THE REAR OPERATOR MOUNTING
Position the rear mounting
at the height previously measured and weld it on the anchorage plate
with two weld points (
C11
).
Check the lengthwise and crosswise alignment of the mounting
(
C12
)
with a water level.
Complete the welding and clean away the residues with a wire brush.
Warning
!
•
Before welding, ensure that there are no bushes (B4 pos. 5) in the mounting, and that the
fitting hole is properly protected from weld residues.
•
When the welded zone has cooled down, apply a coat of anti-rust paint.
3.3
TEMPORARY INSTALLATION OF THE OPERATOR
Temporarily mount the operator to find the correct fixing position of the front mounting.
Warning
!
Handle the operator with care during assembly.
Fit the fork (
C13
pos.
1
) to the operator bottom. Lock the fork with the special pin (
C13
pos.
2
)
and fix both with the two snap rings (
C13
pos.
3
).
Fit the two vibration damping bushes
(
C14
pos.
4
) above and below the mounting.
Position the fork of the operator on to the mounting and lock it with the vertical pin (
C15
pos.
5
)
after greasing abundantly.
Warning
!
Grease both the pin and the housings abundantly
.
G
B
C11
C12
C14
C15
C13
1
2
3
3
Содержание AA10882
Страница 74: ...74...