Manual CE (SAGOMA _GB)
Sezione 13 Part 13. Installation of the payment systems
To install the payment systems always follow the instructions supplied by the manufacturer. For
information only, the installation of a token machine is hereunder described.
Remove the CPU and the
coin-mech protections.
Fit the token machine.
Connect the dialogue cable
to the CPU board.
In the case of Executive standard systems, the cable is supplied by the machine; in the case of
other systems, the cable is supplied by the payment system.
Only for Executive standard systems: connect the power supply cord to the 24V connector placed
in the fitting area of the token machine.
Switch the machine on by inserting the key in the safety switch.
Enter the programming mode (see section "Entry and exit from the programming mode).
Pre-set the specific parameters for the token machine which has just been installed (see section
"Pre-setting of payment systems" and following).
Exit from the programming mode.
The machine is now ready to use the coin-mechanism.
48/48
