G E T T I N G S T A R T E D
Initial Setup
350-11751-01 – updated October 2018
MediaWall V User’s Guide
11
RGB
1.
In the lower-left corner of this screen, choose a unit of measure (inches or millime-
ters) for specifying screen and bezel dimensions.
2.
In the
Screen Dimensions
group, measure either the width and height or diagonal
length of the display area and enter your measurements here. Do not include the
bezel dimensions. You can type values directly, or use the spin controls.
3.
In the
Bezel Width
group, measure the left and right bezel widths and enter your
measurements here. Type a value directly, or use the spin controls.
4.
In the
Bezel Width
group, measure the top and bottom bezel widths and enter your
measurements here.
5.
In the
Timing
group, choose a source of the information the
MediaWall V
needs to
tailor its output signal to match the capabilities of the display:
◆
Set
Use Display EDID
to
On
to have the
MediaWall V
use Extended Display
Identification Data (EDID) from the display as its output timing reference;
– OR –
◆
Set
Use Display EDID
to
Off
. Then,
under
Selected Timing
, choose an
output timing setting that most closely
matches the native resolution and
refresh rate of your wall displays. Click
Apply
to confirm your choice.
6.
Optionally, enter a descriptive name for the display you just defined. Or, use the
default display definition name.
7.
Click
Save
.
Important
If your
MediaWall V
system contains DisplayPort outputs, use the second method
above. (The output timing reference in this case is always the
MediaWall V
internal
timing generator.)
