RF-System TinyGate, Инструкция по сборке и эксплуатации

Страница: 23 / 82

TinyGate - User's manual and assembly instructions
Connection cable for the transceiver
TinyGate allows you to freely define the assignment of the pins on the RJ45 X2
connector. The transceiver is connected to this connector via a patch cable that
is supplied in the kit, to which may be assigned the following signals available
on the JP1 socket:
Signals Description
SPK
Input for the audio signal reception coming from the demodulator
(
AC-coupled
)
This signal, according to the transceiver model, may be available on
the microphone socket, DATA, the ACCessory socket or else on a
jack. You can find indications in the manual of your transceiver if
and where an audio output is available.
Advice: Not all transceivers have all of the necessary sig-
nals (SPK, MIC et PTT) available on a single connector.
The RCA X1 (CW / FSK) socket may be for example also used as an
audio input (or else as any other kind of input or output) if there is
not a necessity to use it as CW/FSK output. This is the case in
where not all signals (SPK, MIC and PTT) are available on a single
connector, but where for example the receiver audio output signal
is present on a separate socket. One should thus remove-cut the
copper trace on SJ1 and take the signal with a wire from the left pad
to the desired signal pin on the right row of the socket JP1 (see im-
age below). This solution requires an extra wire, but avoids avoids
having to assemble a Y-cable between X2 and the transceiver.
MIC Audio output to the microphone input (AC-coupled)
This signal, according to the function of the transceiver model, may
be available on the microphone connector, on the DATA or ACCess-
ory connector. In the event that a DATA or ACCessory connector is
available, it is recommended to use these in order to leave free the
microphone socket, and consequently also the microphone itself.
PTT Relay output for the PTT - (Max 100VDC / 0.5A)
It is a contact that is normally open(NA) to the ground (GND)
CAT power supply input for the CAT/CI-V interface
P a g e 23