REXROTH DIAX04, Руководство по устранению неисправностей

Страница: 86 / 114

5-18
Description of diagnostic letters F... and E... DIAX04 ELS-06VRS
DOK-DIAX04-ELS-06VRS**-WA01-EN-P
Remedy:
First activate command P-0-0012, C300 Command ’Set absolute
measurement’ , and then start command S-0-0148, C600 Drive
controlled homing procedure command . This procedure will define the
absolute reference point.
See also the functional description: "Possible Error Messages During
"Drive-Controlled Homing""
C700 Basic load
With motors of the MHD, MKD and MKE series, the controller parameters
for the connected motor that are stored in the controller are set to their
default values by activating the controller parameters that are stored in
the motor feedback. The drive controller issues the C7 message to
indicate that the
C700 Basic load command has been activated via the
command parameter S-0-0262, C700 Command basic load .
Cause:
The command C700 Basic load has been activated.
See also the functional description "Load Default"
C701 Basic load only possible when drive is not enabled
Cause:
Command S-0-0262, C700 Command basic load cannot be run if the
controller enable is set.
Remedy:
1. Disable controller enable.
2. Start the command again.
See also the functional description: "Error Conditions of the Load Default
Settings Procedure"
C702 Default parameters not available
With motors of the MHD, MKD and MKE series, adapting the control
loops to the connected digital drive is done by activating the speed
controller parameters that are stored in the motor feedback. The drive
controller employs the
C702 Default parameters not available message
to signal that the S-0-0262, C700 Command basic load command has
been activated, but that there is no data memory at the connected motor.
Remedy:
Order the parameter sheet of the employed motor from the INDRAMAT
Service, and enter the parameters.
see also the functional description: "Error Conditions of the Load Default
Settings Procedure"