REXROTH DIAX04, Руководство по устранению неисправностей

Страница: 88 / 114

5-20
Description of diagnostic letters F... and E... DIAX04 ELS-06VRS
DOK-DIAX04-ELS-06VRS**-WA01-EN-P
C801 Parameter default value erroneous (-> S-0-0021)
Cause:
During the execution of P-0-4094, C800 Command Base-parameter
load, a default value that has been stored in the drive was recognized as
incorrect. The related parameter is entered in the S-0-0021, IDN-list of
invalid op. data for comm. Ph. 2 .
See also the functional description: "Basic parameter block"
C802 Locked with password
The parameter S-0-0267, Password offers the possibility to set a write
protection for the drive parameters. The diagnostic message C705
Locked with password indicates, that the command P-0-4094, C800
Command Base-parameter load has been started, although the drive
parameters are protected with the customer password.
See also the functional description: "Basic parameter block"
D300 Command adjust commutation
A correctly adjusted commutation offset is mandatory for the operation of
synchronous motors. The "D3“ message indicates that the command has
been activated, that is used for determining the commutation offset.
Cause:
The commutation setting command has been activated.
See also the functional description: "Determining commutation offset"
D301 Drive not ready for commutation command
Meaning:
The drive must be in torque control mode when the "D3“ command is
started.
Cause:
Activate torque control and start the command again.
See also the functional description: "Determining commutation offset"
D500 Command Get mark position
The P-0-0014, D500 Command determine marker position command
can be used for checking the correct acquisition and position of the
reference marker of an incremental measuring system. The "d5“ display
shows that the command has been activated.
Cause:
The Determine marker position command has been activated.
See also the functional description: "Functional principle of command
detect marker position"