Revo RH16NVR1, Руководство по эксплуатации

Страница: 46 / 82

Part 3 - Configuration
46
- PTZ : Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
• Trip Zone Ignoring Time : The system does
not produce event log entries or issues remote
notifications regarding Trip Zone events detected
during the specified time following the initial Trip
Zone event. Set a value between 1 sec and 5 secs
or choose Never.
Trip Zone Ignoring Time does not affect Trip Zone
recording.
• Daytime Setup : Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
Tampering
• No. : Select which cameras to apply Tampering to.
• Sensitivity : Set to between 1 (Low) and 5 (High).
• Activation Time : Specify how long tampering
detection needs to last in order for it to be
considered an event. Tampering detections that do
not last for the specified duration of time will not be
considered as events.
•
Actions
: Specify which actions to take when
Tampering is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to
Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
- Alarm-Out : Designate event-triggered alarm-out
channels and beeps.
-
Notify
: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
- PTZ : Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
•
Use Ignoring Time
: Select
Time Setup
to specify
the tampering detection ignore time. Tampering
detection will be disabled during the specified time
frame.
Alarm-In
• No. : Enable / disable alarm-ins.
This option includes both local and network camera
alarm-ins. 1 through 16 are network camera alarm-
ins, whereas 17 through 20 are local alarm-ins.
•
Title
: Use the virtual keyboard to enter titles.
• Type : Change the alarm-in type.
•
Actions
: Specify which actions to take when Alarm-
In is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
- Alarm-Out : Designate event-triggered alarm-out
channels and beeps.
-
Notify
: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
-
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.