Revere 45-AC2V, Руководство по обслуживанию

Страница: 161 / 188

INTRODUCTION
Feb 25/11
9105
11 - 3
1. GENERAL
This section provides an illustrated parts breakdown for the purpose of identifying and/or ordering
replacement parts. It should not be used for any other purpose. Figures detail component
location in relation to the overall assemblies and subassemblies.
2. ITEM NUMBERING
In each illustration the items are numbered from 1 and, as a general rule, continue in increments
of 10, e.g., 10, 20, 30, etc., to enable new items to be inserted into the sequence without the
necessity for the complete renumbering of subsequent items.
Upon initial issue all item numbers will be listed without a suffix, enabling other versions of a
particular item to be identified by the same number plus a subsequent letter, e.g. 10A, 10B, 10C,
etc. All letters of the alphabet will be used except I and O.
Items with the same part number but different quantities per assembly will be assigned a suffix as
a variant of the original part number, e.g. 10 and 10A.
3. PART NUMBERING
Revere Supply Co., Inc. part number.
4. ILLUSTRATIONS
A view of each assembly, exploded as necessary to show the component parts is provided. Each
illustration is assigned a figure number. All illustrated parts are assigned item numbers which
correspond to the item numbers on the parts list pages.
When it is not possible to show on the basic illustration all the variants of an assembly, additional
illustrations will be provided. The additional illustrations will bear the same figure number as the
basic illustration.
5. NOMENCLATURE
Descriptions break down by noun name, modifier, and any additional explanatory information.
References to additional figures/charts are displayed in parenthesis following the description.
If the part is purchased from an outside vendor, the manufacturer’s code number preceded by the
letter “V” is shown in parenthesis, followed by the vendor’s part number.