SuperCleanox Operating instructions
Page
59
of 62
The 4-fold brushes can be used as surface cleaners.
This allows cleaning with a width of 100mm in a single work step,
or cleaning intensively.
You can work in a more relaxed way if you screw the handle, with
the extension, on at the side, at an angle of 35°.
Brush adjustment:
Up to four brushes are placed in succession in the direction of cleaning.
Through adjusting the Teflon sheaths on the M brushes to
different lengths, you can adjust the performance of the brush.
Adjust the carbon fibres of the first brush (in the direction of
cleaning) so that approximately 5mm are protruding.
As a result, the carbon fibres are more focused and
more concentrated light arcs are formed.
Adjust the subsequent brushes so that the fibres protrude 2-3mm
further out each time.
The fibres of the last brush should protrude approx. 15-20mm.
The fibre ends fan out further and bring about a smooth transition
at the edge of the weld.
23.4 Extension
With the optional extension, you can extend the handle as desired by
connecting several pieces together, or combine it with knee pieces or
multiple brushes, if required.
Tip
Using an extension not only increases the operating range, but also keeps
your fingers further away from the workpiece so that fewer hot splashes
reach your hands.
23.5 Knee piece
With the optional knee piece, you can adjust the handle to suit your
specific cleaning tasks and workpiece geometries.
If required, you can combine it with extension pieces or multiple
brushes as desired.
1
3
2
4
EP-02-903
EP-02-904