SuperCleanox Operating instructions
Page
28
of 62
14.4 Assembly carbon fibre brush XL / Teflon handle
Use the carbon fibre brush XL for cleaning
welds.
Screw the carbon fibre brush onto the
white Teflon handle.
Tighten the brush firmly.
Note the tip for tightening and loosening
the screw joint.
Safety information:
Make sure that the carbon fibre brush is firmly attached.
A loose screw joint can burn and damage the thread.
The Teflon insulation must be present both on the handle and the
brush, as the high currents could otherwise lead to shunts via the
workpiece.
Green LED on the appliance lights up but no cleaning performance:
No or only insufficient contact on the brush thread.
Clean the thread
Tighten the thread
Tip for tightening and loosening tight screw joints:
Insert the two pins supplied through the cross-holes in the
lower part of the handle and the brush.
You can then apply greater force for tightening or
loosening.
14.4.1 Adjusting the Teflon sliding sheath
During the cleaning process, the carbon fibre
tips of the carbon fibre brush wear out.
By means of the Teflon sliding sheath, you
compensate for the wear on the carbon fibres.
Adjust the Teflon sliding sheath on the
carbon fibre brush so that the carbon
fibre tips protrude by approx. 5-10mm.
The many small arcs between the carbon
fibre ends and the workpiece can only
form if this is correct!
This guarantees an optimum cleaning
effect.
Wrong
Teflon sliding sheath
5 - 10mm
Correct
Pin
Threaded
piece
Teflon
handle
Carbon fibre
brush
