SuperCleanox Operating instructions
Page
51
of 62
6
Drip some drops of marking electrolyte onto the felt until
it is fully wetted.
7
Press the whole surface of the marking stamp vertically
and evenly onto the template.
Brush slowly over the template with gentle pressure.
Marking time 1 - 3 seconds
Otherwise, the surface of the workpiece next to the
template will be darkened.
8
The degree of darkness depends on:
the marking period,
the electrolyte used,
the material.
Make sure you do not brush over the edge of the
template, otherwise the workpiece surface next to the
template will be darkened.
9
When marking/labelling smaller surfaces, work as
follows:
Press the whole surface of the marking stamp
vertically and evenly onto the template.
Move the marking stamp lightly.
The electrolyte then flows through the template more
easily.
10
Take the template off the workpiece.
Flush the workpiece surface thoroughly with water.
Use demineralised or distilled water.
The water hardness must be less than 10° dH.
This prevents unsightly lime stains on freshly marked
template
11
Dry the surface.
Use paper towels.
In this way, you obtain a stain-free, dry surface.
For more information, see the tips for "marking" and "labelling".
Table 9
Workflow dark marking
S
Degree of darkness
Sc
h
