37
If when the system is disarmed the ‘ALARM MEM’ LED
is flashing and the panel beeps every 10 seconds, this
indicates that an alarm has occurred. To cancel the LED
and stop the beeping you must access the event log.
To access the Event Log, (with the system in Standby):
Press .
The Event-Log will automatically start scrolling
through and displaying the event data starting with
the most recent event. The data for each event is
shown on two screens, each screen will be displayed
for 5 seconds before moving on to the next screen
and then the next event.
Use the and buttons to manually scroll
through the event log to the required position as
necessary.
Press to return to standby.
Voice Memo
To record a message, (max. duration 30s), at the
Control Panel using the Voice Memo facility, proceed
as follows:
Press
Press to start recording
While recording, press to stop the recorder
and skip the remaining message time.
If there are already 6 messages recorded it will not be
possible to record a voice-memo message until a
message has been deleted.
The Voice Memo message may be accessed either at
the Control Panel (see Replay Messages) or via the
Remote System Control facility.
Replay Messages
If the ‘MESSAGE’ LED is illuminated, this indicates
that either a new Answer-Phone or Voice-Memo
message has been recorded and has not been read.
The recorded messages may be accessed at the
Control Panel as follows:
Press
Messages are replayed in order starting with the
most recent. Press to skip to the end of
the message.
At the end of each message there will the option of
deleting the message just heard.
To delete the message
Press to delete the message
Press to re-confirm and actually delete the
message.
Note: Press at either stage to cancel delete
and move on to the next message.
After all messages have been replayed the system
will automatically return to Standby Mode.
Remote System Control
If the Remote System Control facility is enabled, the
control Panel will answer the call after the set number
of rings and emit three beeps on the phone line to
prompt for a User Access code to be entered using
the telephone keypad.
A valid User Access code will be acknowledged
with one long beep. An incorrect code will be
acknowledged by two short beeps.
If the User Access code is not entered within 30s or
is entered incorrectly three times then the Control
Panel will automatically hang-up the line.
Note: If the internal Answer-Phone is also enabled
and there is space for a new message then the call
will be answered with the Answer-Phone greeting
message. The User Access code should be entered
during the greeting message, otherwise the answer-
phone message recorder will be activated.
Use with an External Answer-Phone:
If the Remote System Control is to be used in
conjunction with an external Answer-Phone then
1.
The internal Answer-Phone must be disabled.
2.
The number of ‘rings to answer’ for the
Control Panel must be greater than that of
the External Answer-Phone, otherwise the
Control Panel will always pickup the call
before the Answer-Phone.
To access the Remote System Control facility the
Control panel has a ‘double dial-in’ feature to
enable the Control Panel to pick-up the phone
call before the external Answer-Phone cuts in.
The ‘double dial-in’ procedure is as follows:
8
ESC
1
ESC
1
1
3
ESC
?
?
?
?
,
,
User Access Code
4
